Skip to content

Gates

A gate in CytoSpec does not just highlight events: it creates a new data set holding the events inside it. The new data set appears under its parent in the Data Sets panel, in the gate's colour, and can be plotted, gated again, averaged or saved like any other.

Gated data sets are named Gate_1, Gate_2 ... Rename them by clicking the name in the Data Sets panel.

2-D gates

On a scatter plot:

  1. Press the 2 D gate button in the control panel.
  2. Click on the plot to place the vertices of a polygon.
  3. Right-click to finish. The polygon is closed and the gated data set is created.

To change a gate, drag the polygon or one of its vertices; the gated data set is recomputed when you let go. Double-click a gate's outline to select it.

A gate remembers the axes it was drawn on - including principal components and log or linear conversion - and is always applied in those coordinates.

1-D gates

On a histogram:

  1. Show the markers with the marker button and drag them to the ends of the range.
  2. Press 1 D. The events between the markers become a new data set.

Inverse gates

Tick Inverse gate before drawing to keep the events outside the gate instead.

Reusing gates

  • Tools → Breed gates copies the gates of the first selected data set to every other top-level data set.
  • Save Protocol / Load Protocol store gates in a file and apply them to other data - see Saving.
  • Tools → Add Gate Table To Data Table adds the gate membership of every event to the data set as extra channels.
  • File → Save Gate Table writes it to a file.

Note

Analyze → Gate Projection has no action in this version.