LIBSight¶
LIBSight identifies the chemical elements in atomic emission spectra from laser-induced breakdown spectroscopy (LIBS). It reads the spectra from one or two spectrometers, finds their emission lines, and matches them with the known lines of the elements you choose - taken from the NIST Atomic Spectra Database - to show which elements produced the spectrum, in which ionisation state, and how much of its line signal each one accounts for.
This manual describes LIBSight version 1.5 (Windows 64-bit). Up to version 1.4 the program was called sibs.
What LIBSight does¶
Reads the spectrometers. Pairs of files from a two-spectrometer set-up are merged into one continuous spectrum; single blended files and Andor camera files are read directly.
Finds the lines. The spectrum is filtered, its noise level estimated, and its emission peaks extracted.
Explains the lines. Of the elements enabled in a periodic table, LIBSight finds the ones whose key lines are in the spectrum more often than chance would put them there, and puts every peak down to one of them. Every peak is labelled with its ion, and the elements are listed with the part of the peak signal on their lines. A battery black mass gets the elements it is made of and the cathode chemistry they point to.
Compares with controls. The Unmixer II window expresses a sample spectrum as a mix of a solvent spectrum and control spectra measured on the same instrument.
Where to start¶
-
First time? Installing and launching and A tour of the window.
-
Loading data? Opening spectra.
-
Choosing elements? The periodic table.
-
Reading the result? Identifying elements.
Conventions used in this manual¶
| Convention | Meaning |
|---|---|
| Bold | A button, box or checkbox you can see on screen |
Monospace |
A file name, folder name or literal value |
| ion | An element in one ionisation state, written with a Roman numeral: Fe I is neutral iron, Fe II singly ionised iron |
| WL | Wavelength, in nm |