Skip to content

Ribbon plot

A ribbon plot shows one histogram per parameter, side by side, for the population feeding the node. Each parameter gets a vertical strip whose width at every height reflects how many events are there - a violin-like profile.

It answers "what does this population look like across all my channels?" in a single picture, which is exactly the question a gating strategy leaves open.

Create one with Ribbon Plot on the project panel toolbar.

Choosing the parameters

Click the X axis to open the parameter checklist. Check the channels you want as ribbons, in the order you want them.

The selection is remembered in the data folder's INFO folder, so a new ribbon node on the same plate starts from the same list.

Reading it

  • All the ribbons share one scale, so heights are directly comparable between channels. The scale has its own bar along the axis - see Parameters and scales.
  • A wide bulge is a dense population; two bulges are two populations in that channel.
  • Positive channels stand out immediately against the ones sitting on the negative.

Display settings

Ribbon plots follow the global display settings on the MoreOptions page:

Setting Effect
Histogram Bins Resolution of every ribbon
Equalize Spread the density over the whole colour range so faint parts show
Gamma for Color Scales and Gamma Shape Shape the colour ramp
Butterfly Ribbon Plot Mirror each profile about its axis
Log Butterfly Profile Use a logarithmic profile width
Color map for Bars and Spectra Plots The palette
Sort Ribbon Plot Order the ribbons rather than leaving them in selection order

Feeding it

Drag a gate's output pin onto the node, exactly as for a chart node. The ribbons then describe only the gated events.

A ribbon node is often the right thing to hang off the last gate of a strategy: one node that summarises the final population across every marker.

Comparing populations

To compare two populations, make two ribbon nodes with the same parameter list and feed each from a different gate. Put them side by side on the canvas and the differences are immediate.

For comparison across wells instead - a titration or a dose series - use a well ribbon plot instead.