Skip to content

Plate Editor

The Plate Editor - the Legend info tab - is where you say what each well is: a positive control, a negative control or a sample, the analyte it stains for, the dye, and any comments. It is the plate's legend, kept with the data, and the Unmixer reads its controls from it.

Filling it in

The tab shows a picture of the plate. Click a well to select it, drag to select a rectangle of wells, Shift +click to add or remove one. The fields beside the plate show the well selected, and what you type goes into every well selected:

Field Holds
File The FCS file in the well (read only)
Well Type Positive, Negative or Sample
Analyte The marker the well stains for, CD4
Dye The fluorochrome, BV
Emission Peak The dye's number, 650
Comments Free text, as many lines as you like
Plate Name A name for the whole plate
384-well Draw the plate as 384 wells instead of 96

A dye whose name ends in a three-digit number is split as you finish typing it: BV650 becomes Dye BV and Emission Peak 650. Wherever the dye is passed on it is joined again. The unmixer gets it in the spelling of the spectra database - the dye list it names its controls by - when that knows the dye (PE-Fire 810). The plate and its Export put a space before the number only after a dye of several words: BV650, Spark Blue 574.

Button Effect
Stamp Copy the selected well's - or wells' - entries onto others: press it, then click the wells to stamp. Right-click to put the stamp back
Clear Empty every well
Undo / Redo Step back through your changes, or forward again. They appear once there is something to undo or redo
Save Write the editor's contents into the data folder - see below
Load Read a saved Plate Editor file, this plate's or another's, or an old .cin cell-info file
Export Write every well's entries to a text file
Print Print the plate
Close Put the editor back on its tab, when it was torn off

Apply and To CSV do nothing in PlatAnJr.

Saved by file, not by well

Save writes INFO\PlateEditor.ini in the data folder. Each entry is filed under the name of the FCS file, not the well it sits in, so what you said about a file follows it: open the plate again with a different plate map, and each file's type, analyte and dye are in whatever well the file is now. A well with no file cannot be saved, and the editor says how many it left out.

Opening a plate reads its PlateEditor.ini. Opening the same plate again keeps what the editor had of each file, saved or not. Load of another plate's file fills in the files the two plates share and passes over the rest; an old .cin file is read well by well, as it was written.

The editor and the unmixer

The Unmixer's panels and the Plate Editor share what they know about each control:

  • A panel takes its well's type, analyte and stain from the Plate Editor first, ahead of what the file name says and ahead of an Unmixer node's saved configuration. A field left blank in the editor is filled from the file name.
  • What the unmixer reads from a file name, and anything you change in the unmixer, is written back to the editor - and to PlateEditor.ini - at once.

So the place to correct a mis-named control for good is the Plate Editor: the correction is saved with the plate, and every later unmixing of it starts from there. See Naming the controls.

Tearing it off

Drag the Legend tab's caption away to float the editor in a window of its own, beside the plate - see Tearing off a tab. Close docks it back.