Well ribbon plot¶
Where a ribbon plot shows one parameter per ribbon, a well ribbon shows one well per ribbon, all of the same parameter. It is the node for titrations, dose series, timepoints and any comparison that runs across the plate.
Create one with Well vs Parameter plot on the project panel toolbar. The wells currently selected on the plate heat map become the ribbons, so select your wells first.
Setting it up¶
| Action | Result |
|---|---|
| Click the X axis | Change which wells are shown |
| Click the Y axis | Change the parameter being compared |
| Select wells on the heat map, then create the node | The selection becomes the ribbon list |
Each ribbon carries two gates: a negative and a positive band. PlatAnJr places them automatically from the shape of that well's distribution; drag either band to correct it. A band you move by hand is remembered, so replotting does not undo your correction - Reset clears the manual bands and returns everything to automatic placement.
The tabs¶
- Table
-
One row per well:
Column Meaning Parameter The well NegMedian Median of the negative population PosMedian Median of the positive population rSD Robust SD of the negative and of the positive population Stain Index (PosMedian − NegMedian) / (2 × rSD of the negative)Export writes the table as CSV.
- SI Plot
- The stain index across wells as a curve. For a titration this is the answer: the antibody concentration at the peak is the one to use.
- Variance
- The spread across wells, for judging whether a difference in medians is meaningful.
- Histogram
- The distribution of the well you clicked, with its two bands drawn on it. Click a ribbon to bring its histogram up here - this is where you check and correct a band placement.
Double-click the splitter to hide or show the table and plot and give the ribbons the whole node.
Show %¶
The Show % checkbox switches the ribbons between absolute counts and percentages, which matters when the wells contain different numbers of events.
Statistics are computed on linear values¶
Medians, robust SDs and the stain index are computed on the linear data, even though the bands are drawn and dragged on the display scale. A spread statistic is only meaningful on linear values, so the numbers in the table are not affected by which display scale you happen to have chosen.
A titration in five steps¶
- Acquire the dilution series, one well per concentration.
- Open the plate and select those wells on the heat map.
- Gate down to the population of interest and feed a well ribbon node from that gate.
- Set the Y axis to the antibody's channel; correct any badly placed band on the Histogram tab.
- Read the peak off the SI Plot, and Export the table for the record.