Skip to content

A complete analysis

This page takes one plate from FCS files to ploidy levels. Each step links to the page with the details.

1. Open the plate

Click the open-plate button and choose the plate folder. If a legend file for the plate is found it is imported, and its plate ID appears on the toolbar. See Opening plates and The legend.

2. Choose the reporter

Under REPORTER, choose the DNA-dye parameter - for example FL3-H or DAPI-H. Double-click it to make it the default for every plate.

3. Remove debris

Draw a noise gate around the intact nuclei, typically on the reporter against side scatter or reporter area against height. See Noise gates.

4. Define the peaks

Press +A to find the peaks of the whole plate automatically, or add them one by one with +. Drag the band edges so each band covers one peak across all wells; click a band to rename it. See DNA peaks.

Check the histograms in the well table. Click a peak flag to exclude a wrongly fitted peak in a single well.

5. Assign ploidy levels

On Ranges For Ploidy, choose the diploid peak under Select Diploid Peak - or type the position of a 2C reference - and set Range (%). Every well gets a ploidy level, shown in the Ploidy column and on the Ploidy Levels tab. See Ploidy ranges.

6. Hybrids and aneuploidy (optional)

If the samples contain an internal standard, right-click the control wells in the well table to mark them, choose the peaks on the Hybrid tab and read the ratios, C-values, ploidy levels and chromosome counts on Ploidy Table. See Hybrids and aneuploidy.

7. Report and export

Export to CSV File under the well table, Print, the report button, or EZ Export into your Excel template. See Reports and exports.

8. Save

Press SD to store the analysis with the plate. It is also saved automatically when you open another plate or close Xploid. See Projects and defaults.