Skip to content

Opening a plate

Opening

Click the open-plate button, the first on the toolbar, and choose the folder that holds the plate's FCS files. The dialog starts in the folder you opened last.

Mplex maps the files onto wells and loads them into one data set. A plate whose wells go beyond row H or column 12 is shown as a 384-well plate, otherwise as a 96-well plate.

Autofill

Hold Shift while clicking the open-plate button to turn off automatic filling of the plate layout.

When the plate opens, Mplex also:

  • creates an INFO folder inside the plate folder if there is none;
  • loads the plate's legend and its excluded wells;
  • loads the plate's default gates, if they were saved with Set As Default - see Projects and defaults;
  • clears any previous gates and calibration.

The file label on the toolbar shows the folder and the total number of events.

Adding a second plate

Hold Ctrl and click the open-plate button to add another plate to the one already open. The events are appended and the label lists both folders.

Preview mode

A plate of 384 wells can hold tens of millions of events. Preview - the second toolbar button - loads only part of each well:

Setting (Options tab) Effect when Preview is pressed
Preview Downsizer ticked Load one event in N, where N is chosen in the list (1/2 ... 1/100)
Preview Max Cells/Well ticked Load at most this many events per well (1000 by default)

The icon shows whether preview is on. Preview applies when a plate is opened; reopen the plate after changing it.

Warning

Numbers computed in preview mode are based on part of the data. Turn Preview off and reopen the plate before exporting final results.

Excluding wells

Right-click a well on the plate map to exclude it from every calculation - a well that was mis-pipetted, clogged or empty. Right-click it again to include it. Excluded wells are remembered with the plate and with the project.

Excluding a standard well removes that point from the calibration curve.

Renaming the data files

The rename button renames every FCS file of the plate to <plate name>_<well>.fcs, for example r1014_B7.fcs, after asking for confirmation. Use it when the acquisition software wrote names that do not identify the well.

History

The history button lists recently opened plates and recently used projects. Choose one to open it.