Projects and defaults¶
A project is the analysis without the data: the noise gate and whether it is used, the bead gates with their names, the assay, the reporter, the axes and the excluded wells. Apply a project to another plate of the same kit and the whole analysis is repeated.
Project files¶
Save project writes a .pap file, starting in the plate's INFO folder. Load
project reads one and applies it to the open plate. The project label on the toolbar
shows the open project.
New clears the gates and the assay and starts again; the plate stays loaded. If you have unsaved changes you are asked first.
Defaults stored with the plate¶
After Save project writes the file, you are asked whether to make it the open plate's default. Yes copies the saved project into the plate's INFO folder, replacing any existing default. No leaves the default unchanged. This prompt is available when a plate is loaded and is skipped if the saved project is identical to its default.
The default is loaded automatically whenever the plate is opened - the quickest way to come back to a finished plate.
Unsaved changes¶
Mplex notices when the analysis has changed since it was last saved or loaded. Before a command that would discard the changes - New, Auto Gate, Semi Auto, closing the window - it asks Project is not saved. Would you like to save it?
- Yes - choose a project file to save, then choose whether to make that saved project the plate's default.
- No - discard the changes and carry on.
- Cancel - do nothing.